Dspx chat mode

You can use the chat mode to access the internal setup information in the signal processor (RVP).

Enter chat mode directly by starting dspx without the –nochat argument.

Alternatively, enter chat mode using the chat command.

To begin the dialog with RVP, press ESC.

In chat mode, you can access the TTY setup commands from the host computer, as if it were a terminal plugged directly into the DSP.

When you are in chat mode, the normal square-bracket prompt disappears.

For information on TTY setup commands, see RVP10 User Guide (M212604EN).

Command List:

F: Use Factory Defaults
S: Save Current Settings
R: Restore Saved Settings
M: Modify/View Current Settings
Mb – Burst Pulse and AFC
Mc – Board Configuration
Mf – Clutter Filters
Mp – Processing Options
Mt<n> – Trigger/Timing <for PW n>
Mz – Transmitter Phase Control
M* – Stand–alone Settings
M+ – Debug Options
P: Plot with Oscilloscope
Pb – Burst Pulse Timing
Ps – Burst Spectra and AFC
Pr – Receiver Waveforms
P+ – Visual Test Pattern
V: View Jumpers and Status

?: Cmd list (?? Settings list)

*: Power–Up Reset

Q: Quit

To disconnect the terminal from the DSP, type: q
Dspx waits for you to press Ctrl/C, then returns to the dspx prompt:
```
> q

Exiting Setups...

^C

[110] : 
```