Interactively Updating Configs from Results

Interactive update is only available for the LDR offset.

This is a feature which automatically changes your LDR offset in the setup_dsp.conf file, and put it into use. It displays the difference, and prompt you to answer y if you want to make the change. It is up to the operator's judgement to determine if this is a normal drift, or if something has broken in the receiver and the change should not be applied.

When changes are made, they are logged to the /var/log/irisrda/messages and /var/log/irisrda/sigmet.log files.

You can skip the BEAM processing phase, and pick up processing just at the Interactive Update phase by calling Suncal with the -update command line argument. This reads in the most recent suncal_results file.

If you run Suncal automatically from the IRIS task scheduler, if a change is detected, you are prompted to run suncal -update manually.