Non-network antenna angles to RVP
RVP supports the following techniques for bringing-in antenna tag angles:
- Parallel binary or BCD "TAGS"
- S/D convertor
- From RVP internal simulator
For information on the question, see RVP10 User Guide (M212604EN).
In these selections, you must configure the
setup/RCP section of the RVP Setup utility to
specify the serial line input as follows:
| setup/RCP | |
|---|---|
| System has antenna | Yes |
| Main Interface to RCP | None |
| Antenna angle insertion source | Native RVP |
Alternatively, use a serial line input to RVP.
In this case, you must set the response to None. Also, you must configure the
setup/RCP section of the RVP Setup utility to
specify the serial line input as follows:
| setup/RCP | |
|---|---|
| System has antenna | Yes |
| Main Interface to RCP | Serial |
| Antenna angle insertion source | Normal RCP |
| Is this the 1 controlling host | No |
| Main serial device name | /dev/ttyS1 |
| Running at | 19200 |
| With parity | None |
| Receive format from RCP | RCV01 |