Calibration Parameters

All of the calibration parameters are taken from the Setup utility, and they serve as a check that Setup was properly configured.

If you see an error in these parameters, exit the Zauto utility, and correct the error in Setup before attempting a calibration. Otherwise, the calibration will be incorrect.

The following Setup parameters are displayed:

• Radar wavelength (cm)
• Transmit power (kW)
• Digital filter loss at calibration (dB)
• Horizontal and vertical beam width (degrees)
• Antenna gain (dB)
• Burst power at calibration (dBm)
• Transmit loss (dB)
• Receive loss (dB)
• Siggen loss (dB)

These values remain fixed throughout the Zauto procedure.