Reset (RESET)
The RESET command permits resetting either the entire RVP10 processor, or selected portions. Flags in the command word determine the action to be taken.
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
---------------------------------------------------------------
| | | | | | | | | | | | | | | | |
| |Nv |Nse|Fif |Nv |Nv | 0 1 1 0 0 | Command
|-----------------------|---|---|----|---|---|-------------------| Nv-
Reloads configuration from the saved nonvolatile settings.
Nse-
Reset the receiver noise levels to the power-up default value for all pulsewidths as defined in the Mt setup questions. See Mt<n> — Transmit sequence #n.
Fif-
Remove any data currently in the output FIFOs. This permits flushing output data that was left from a previous command, so that new output can be read from scratch.