IRIS/TDWR Configuration Summary

You must install and configure the TDWR components by performing the following procedures.

  1. Configure IRIS for TDWR operation.
    1. Configure the runway arenas (protected areas).

      See Configuring Protected Areas (Arenas) for TDWR.

    2. Configure the scan tasks and the SLINE and SHEAR products.

      See Configuring IRIS Tasks and Products for TDWR.

    3. Configure the outputs to the Integrator and the SD's.

      See Configuring IRIS Product Outputs for TDWR.

  2. Install and configure the Ribbon Displays. See:
  3. Configure the TDWR/LLWAS Integrator (runways.conf).

    See TDWR/LLWAS Integrator and Runways Utility.

  4. Use the runways utility to set the runway direction.

    See Runways Utility.