Network Status Reports

Figure 1. RCP Network Status Configuration Parameters
Reporting

Select Enabled or Disabled. If enabled, the following options appear:

  • Status fault polarity

    Select either Active HIGH or Active LOW.

    Since the site status bits in the XMT02/04/05 formats are set to 1 when a site is okay, the recommended fault polarity is Active LOW.

  • Initial state of sites

    Select the initial fault status of all four sites as either All Okay or All Faulted.

  • Radar Workstation 'A' site code, ...

    Enter the site codes whose fault status is to be reported to the RCP for each of the possible Radar Workstation sites and Data Processor sites.