Packet and Data Logging

Figure 1. RCP Packet and Data Logging Configuration Parameters
Produce log files on disk

Choose either Yes or No.

You can use antenna log files to debug errors in the antenna position, BITE packets, Time packets, and INU packets.

When enabled, a log file called ${IRIS_LOG}antlib.log is created. This log file is rotated using log rotate, as configured by /etc/logrotate.d/sigmet-antlib. These files are also used to produce the BITEX histograms.

Log incoming Antenna I/O Packets
Choose either Yes or No to log incoming Antenna I/O Packets in the antenna log file.
Log incoming BITE I/O Packets
Choose either Yes or No to log incoming BITE I/O Packets in the antenna log file.
Log Incoming Time I/O Packets
Choose either Yes or No to log incoming Time I/O Packets in the antenna log file.
Log unrecognized I/O Packets
Choose either Yes or No to log unrecognized I/O Packets in the antenna log file.
Log AZ/EL data insertions
Choose either Yes or No to log the AZ/EL position of the antenna in the antenna log file.
Log INU data insertions
Choose either Yes or No to log INU data in the antenna log file.