Checking Debug Options with the M+ Command

Test Goal

Verify that the TTY setups for the Board Configuration section are properly configured for the customer application.

Background

RVP10 supports several test features that are configured in this section.

Vaisala recommends that the LEDs be set to 1:Go/Proc so that the front panel red LED flashes during each processing cycle.

For operational systems, turn off the simulation feature.

Test Equipment

KVM connected

Test Procedure

  1. Enter the TTY setups through dspx.
  2. Issue the M+.
  3. Set all the values, as required.

Checklist

Debug Options Checklist
Task Checked OK/Not OK Remarks
Test procedure completed successfully.

Parameters are set.

See M+ Debug options.
Parameters have been set.
Test Passed
For Customer Date:
For Vaisala Date: