Recording RAW Data Automatically

You can configure a RAW product automatically when the associated task runs.

Because RAW products require substantial disk space, it is best to record them "on the fly," so they are not automatically deleted by the disk Watchdog.
  1. Configure the RAW product.

    See Configuring RAW products.

  2. Load the associated tasks in the TASK Scheduler and select Go.
  3. In the Product Scheduler menu, load the product and choose All.

    This causes the RAW product to be generated every time the task runs.

  4. In the Product Output menu, specify the desired archive media as the output device and choose All in the header line for the product, so all output is sent to the archive.
  5. In the Archive menu, mount a tape or disk and select Commands > Record.